Ipv6 Address Example Cisco. This chapter introduces the three types of ipv6 addresses: I can also ping vlan 10 interface.
An example of an address is given below: Example ipv6 configuration on cisco. Here is the config used on the router interface for slaac.
And The Last Entry Would Be The Address Portion Of A Default Route.
Information may also be displayed about the status of ipv6 neighbor redirect messages, ipv6 neighbor discovery messages, stateless autoconfiguration, and mtu size. In the following example, both cisco express forwarding for ipv6 and network accounting for cisco express forwarding for ipv6 have been enabled globally on a nondistributed architecture device, and cisco express forwarding for ipv6 has been enabled on gigabit ethernet interface 0/0/0. An ipv6 packet sent to a unicast address is delivered to the interface identified by that address.ipv6 addresses are denoted by eight groups of hexadecimal quartets separated by colons in between them.
We Begin This Section With A Brief Look At The Ipv6 Address Space And How The Different Types Of Addresses Are Allotted Within This Space.
Ipv6 address types are defined in rfc 4291, ip version 6 addressing architecture. Most operating systems, including cisco ios and microsoft windows, accept the placement of a single double colon (::) in any valid location. Now, let’s explain these ipv6 address types and their sub types detaily.
Mainly, There Are Four Address Types In Ipv6.
Cisco software supports the ipv6 unicast address types described in the following sections. Configure ipv6 remote triggered black hole with ipv6 bgp. An example of an address is given below:
In The Following Example, The Show Ipv6 Interface Command Is Used To Verify That Ipv6 Addresses Are Configured Correctly For Fastethernet Interface 1/0.
It does not look like the loopback ip address, but that is what is it. Example ipv6 configuration on cisco. Next, we examine the various addresses within three ipv6 address types:
This Feature Is A Key Benefit Over Ipv4 As It Eliminates The Need Of Manual Configuration Or Dhcp As In The World Of Ipv4.
Combining rule 1 and rule 2. To understand the structure of an ipv6 address, let’s give an example: Configure prefix delegation in vpdn scenario.